Hey, I just saw this in Rocklers catalog https://www.rockler.com/dust-right-r...ado-dust-chute
The traditional dust port on the router fence only works for edge routing. Who hasn't been groove routing and seen this line of dust shooting out in front of the workpiece?
So I'm thinking I could make one of these for my shop vac hose. Fastened to the bottom edge of the end of the router table in line with the bit and just below the top so long workpieces can run off the end of the table. Probably the bristles aren't necessary if you have a good suction.
The traditional dust port on the router fence only works for edge routing. Who hasn't been groove routing and seen this line of dust shooting out in front of the workpiece?
So I'm thinking I could make one of these for my shop vac hose. Fastened to the bottom edge of the end of the router table in line with the bit and just below the top so long workpieces can run off the end of the table. Probably the bristles aren't necessary if you have a good suction.
Comment