capncarl
Veteran Member
Last Activity: 11-17-2025, 11:46 PM
Joined: 01-26-2007
Location: Leesburg Georgia USA
-
Some of our painter contractors used a cream type coating to prevent oil and epoxy paints and caulkings from sticking to their hands. It washed off with... -
On a previous miter saw the blade lock didn’t properly bind up the blade and would let the blade slip at the most inappropriate times. I used a... -
The large rubber bands like Lee uses is probably a good thing to have near the miter saw! That way you have something handy to use for a tourniquet! -
I usually put on a pair of leather gloves when changing miter saw blades. Too much exposure to blade, wrench slipping, blade lock slipping, Good chance...Leave a comment:
-
Lchien, you are probably finished with your project, this is what I meant by using an oscillating saw. Then chisel out the remaining material
...Leave a comment:
-
Have you tried using an Oscillating saw to plunge a square hole?Leave a comment:
-
It’s not intended as a contact point. The blade is small and wears out as fast as butter on a hot pan and the operator (Jim) forces it against the... -
Dazzle them with facts?
I Fully agree with Stubbys point that if tablesaw users would leave the guards on the machine accidents would be greatly...Leave a comment:
-
Watching a u tube yesterday of Stubby talking about the proposed gov mandate concerning saw stop type technology on table saws in rhe future. The stubby...Leave a comment:
-
Pole saws are difficult for mere mortals to operate. I’m assuming that by the history you gave this is a manual saw….. even more difficult....Leave a comment:
-
Too much stuff? -
There is one tv commercial airing now where the paid actor is pushing a near 5’ wide piece of plywood on a tablesaw, something that anyone with...Leave a comment:
-
We have a simular Ryobi sidewalk edger, 40 volt. 2 rear wheels. The wife prefers this one over the weed eater atachment like yours because she dislikes...Leave a comment:
No activity results to display
Leave a comment: