Carlos
Veteran Member
Last Activity: Today, 02:08 AM
Joined: 01-12-2004
Location: Phoenix, AZ, USA.
-
I love 22 minute videos that just show you what you can see in a chart in 15 seconds. What was the point?
My brother had one of the older... -
I haven't priced out a large jointer and helix headed planer, so I'm not sure on pricing. What you get with the combo unit is a HUGE jointer. I've often...Leave a comment:
-
You should ask your airline or the shipping company. I would guess boats are less concerned, especially if your stuff is in a steel container....Leave a comment:
-
Do you have a planer? Have you considered the combo units? Saves space, concentrates your dollars spend on blades, and gives you a huge jointing surface....Leave a comment:
-
I don't know anything about parallelogram jointers. I've owned two small jointers, a Harbor Freight (barely usable) and a Jet (fine machine, but small...Leave a comment:
-
Interesting. This is copper to wood, so slightly different from that video. But a copper rod could be glued into the wood, and then hammered until it...Leave a comment:
-
Not really special permission, but airlines COULD restrict them. You are always allowed two batteries up to 100 each. I've never been questioned....Last edited by Carlos; 11-07-2019, 11:14 AM.Leave a comment:
-
It's in the linked page, yes. 12v and 12 amp hours.Leave a comment:
-
The photos above show the construction. It's probably not a big deal to cut half way through one of those 1x2s that make up the structure. On the other...Leave a comment:
-
It's flat bar stock sitting flat on the top edge. That's part of the look I'm going for. It will need at least two screws to be solid. I grabbed some...
Leave a comment:
-
Good idea, I've kicked around a few thoughts like that. The notch would have to be quite deep, and I'm concerned about rigidity/strength loss. But it's...Leave a comment:
-
What hardware to use on a copper strip
I'm making a serving tray from bird's eye maple that will have two brushed copper strips on top as handles. I need to attach the strips using some sort... -
With the DC inside of a 3/4 plywood "shed," very little noise gets out. I also mounted the motor on a piece of rubber mat, with rubber isolators,...Leave a comment:
-
As a young adult I was a 9.5W, and at some point around my 30s I had to go up half a size. Vanity sizing for shoes?? LOL
The wife is very...Leave a comment:
-
Those were two of my inspirations, along with one other. It flips over pretty easily and stays balanced if you center the tools. I ended up offsetting...Leave a comment:
-
I guess I'm making a glue rack to sit just inside the garage door... It's in a long hallway that's not really seen unless you're going into the garage...Leave a comment:
-
I'm in AZ where we don't do this idiocy. I voted "get rid of it" although I don't really care as it doesn't affect me. I do know that many of...Leave a comment:
-
Also, I think it explains the difference between Taiwan and China on this chart: https://www.worlddata.info/average-penissize.php...Leave a comment:
-
I've found very little variation over various tapes and rulers, but have found one or two that were clearly bogus. I check each new tape against a known...Leave a comment:
No activity results to display
Leave a comment: