With the plethora of all kinds of spray can oil products at home centers and automotive shops, it seems like that should do. My 21 year old riding lawn tractors Craftsman LT1000 is going strong but getting under and lubing in hard to reach places isn't getting the job done with WD-40 and other spray can products. Seems like the spray cans don't hold half as much as they used to either. I am running out of spray too often now.
Anyway, I want to spray some OIL on some of the moving parts - cables, levers, moving pulleys that tighten the belts to put in mowing position) springs etc. WD-40 is not preventing rust or lubricating enough, IMO. I would like a good oil can with a long squirt spout to pin point where the oil goes. Even the WD40 6 inch nozzles don't quite pin-point enough as I have to contort my arms to do that.
I would like a good shop oil can with a wide base so it doesn't fall over at a whim and at least a pint and 10 to 12 inch spout.
Are there any good shop cans around? I am a little skeptical of the Chinese products - as much from being shipped FROM China and taking a week to 2 weeks to get here even on Prime. I do not like that time frame.
I went back and looked at Lorings post a year ago on his oil can in which the pump "froze" while covered with oil! Did you ever get it fixed?
Anyway, I want to spray some OIL on some of the moving parts - cables, levers, moving pulleys that tighten the belts to put in mowing position) springs etc. WD-40 is not preventing rust or lubricating enough, IMO. I would like a good oil can with a long squirt spout to pin point where the oil goes. Even the WD40 6 inch nozzles don't quite pin-point enough as I have to contort my arms to do that.
I would like a good shop oil can with a wide base so it doesn't fall over at a whim and at least a pint and 10 to 12 inch spout.
Are there any good shop cans around? I am a little skeptical of the Chinese products - as much from being shipped FROM China and taking a week to 2 weeks to get here even on Prime. I do not like that time frame.
I went back and looked at Lorings post a year ago on his oil can in which the pump "froze" while covered with oil! Did you ever get it fixed?
Comment