twistsol
Veteran Member
Last Activity: Yesterday, 10:55 PM
Joined: 12-27-2002
Location: Cottage Grove, MN, USA.
-
MFT is Multi Function Table ... the Festool table with the 20mm holes on a 96mm grid. There are now lots of metric clones and also Kreg which uses 3/4... -
The file is attached. The template is from Visio 93 or 97, so it should work with any version of Visio imaginable....Last edited by twistsol; 11-27-2021, 10:03 PM. -
Finished the fireplace last night and cleaned up this morning. Wife has to touch up the paint where I dinged the walls because I paint like a 5 year old...
Leave a comment:
-
I've used Visio with a set of templates created by Harvey Chute many years ago. His site has been offline for at least a decade, but I have the templeate...Leave a comment:
-
I heard the chicken cannon story originally at Boeing in. 1987 when I worked on a failure simulation system for them as a contractor. The version I was...Leave a comment:
-
-
I looked at the picture and thought they were sitting on a pickup truck bed which set the scale in my mind. Then I read the description and couldn't fathom... -
Something completely insane. There is a walking / bike path that goes between our house and the neighbors. My wife didn't like that there were Christmas...Leave a comment:
-
I have zero on hand at the moment. On the old tractor there was a box of them under the seat. I'd buy two dozen at a time for about $40. If I managed... -
Bigger snow blowers with more power handle the ice better. The 72" snowblower I had attached to my 48HP tractor when we lived in the country would...Leave a comment:
-
Ever since college, I've categorized (nearly) everything I buy as either disposable or permanent, or income earning, and make my purchase decisions based...Leave a comment:
-
After a Sam's Club run this morning, I Cut alot of stone today. I discovered the black walnut slab I used for the mantel had a twist so the back of it...Leave a comment:
-
I hope mother nature comes through so you GET to use your new snowblower. Then she should knock if off so I don't HAVE to use mine.
I...Last edited by twistsol; 11-20-2021, 11:02 PM.Leave a comment:
-
The assembly instructions require the following:- 3/8 inch nut driver
- Socket wrench with 7/16 inch socket
- Adjustable wrench
- 3/4 inch open end wrench
- #2
Leave a comment:
-
Genesis/Hyundai is no different than Honda/Acura, Toyota/Lexus, Nissan/Infiniti etc. If you want to impress people, Buy a Hyundai Sonata and tape $30k...Leave a comment:
-
I've used mine for non through cuts and on the router table.
I keep the 1/4th leg installed on one side and the 1/8th on the other with the...Leave a comment:
-
I left work at 2:00 yesterday to try my hand at stone cutting for the fireplace hearth. My goal for the first attempt was to get it close enough that...
Leave a comment:
-
Brother in law and Festool rant
My brother in law has on occasion given me crap about my collection of Festools and in particular my Kapex. I paid $1200 for it in 2008 (or my wife did...
-
Yesterday, got up way too early and drove my wife to the doctor for a colonoscopy, drove 40 miles to a friends house who used to install granite to pick...Leave a comment:
-
twistsol commented on LCHIEN's to Now that my Grandsons are all too old, I decided to make a toy carGrandpa made a toy for her. Was there any doubt?
No activity results to display
Leave a comment: