As I continue the planning for my new shop the DC setup is causing much thought and head scratching. I have read most of the posts on the site related to DC including the great setups of LarryG & dbhost to name a few.
I have a Delta 50-760 and am considering adding the Super Dust Deputy cyclone as a prefilter. Now I am doing the 4", 5". 6" piping puzzle. As usual its cost vs efficiency and the old chestnut of whether more than 4" with the 50-760 will actually do any good anyway.
At this stage I am simply searching around to see where one can source the pipe work and fittings. If I go with metal then there are lots of places online to source from. If you start to look for the PVC pipe work I am at a loss as all I can find is the over spec'd sch 40 which is expensive. If I understand right then the lightweight waste pipe (sch 20?) is what is needed but I can't seem to find it anywhere.
So team, where have you folks found to source your DC pipe and fittings?
I have a Delta 50-760 and am considering adding the Super Dust Deputy cyclone as a prefilter. Now I am doing the 4", 5". 6" piping puzzle. As usual its cost vs efficiency and the old chestnut of whether more than 4" with the 50-760 will actually do any good anyway.
At this stage I am simply searching around to see where one can source the pipe work and fittings. If I go with metal then there are lots of places online to source from. If you start to look for the PVC pipe work I am at a loss as all I can find is the over spec'd sch 40 which is expensive. If I understand right then the lightweight waste pipe (sch 20?) is what is needed but I can't seem to find it anywhere.
So team, where have you folks found to source your DC pipe and fittings?
Comment