DIY roller holder (rear rip fence bracket) design

[LCHIEN]

Got this off the internet at some point if you want to make your own replacement

[black2nd]

I'm going to try making this as my rear clamp just fell apart today. Thanks for posting it.

[LCHIEN]

The metal aftermarket replacements on eBay are very good... saves a lot of work and supremely durable.

with all the parts There have been just the holder block alone but not at this moment.

https://www.ebay.com/itm/29618484102...Bk9SR-jhueWyYw

[leehljp]

Curious - Wasn't this posted some years ago - 10- 12- 15 years ago? Even if it was - it certainly deserves post again. Thanks Loring!

[twistsol]

Here is the original article on this site.

https://www.sawdustzone.org/articles...mp-replacement

[dbhost]

I can attest to the quality of the aftermarket roller holder / fence tailpiece. Should outlast the rest of the saw by a large margin.

[LCHIEN]

Not DIY, but Amazon currently sells the all metal aftermarket roller holder complete w/ metal roller screws and clamper for less than eBay sellers... $42



https://www.amazon.com/Complete-Clamperbracket-bracket-assembly-969154002/dp/B09B3PXVCC/ref=sr_1_1?crid=OTJLZKCT29MF&dib=eyJ2IjoiMSJ9.Dpej H1j-SYPyZFkneT36IjrMOfMxlHfRJnH_2dimc4NG0L_Gu-GydJeRFgu5PvhQqio9s3YIuhqAsXFWkRllQFTNCVpjbkrWb7DP Vn9JFhi81zrQNcLBgrWDp5NytfcMqTYaqZLNggSEF-2Ma2kF20UKWSPCVBjHX3GlASf9po782Ew5rItVbz510mnjHR_a l1mFCxW4qXrzZxVglpN51LN9zBe1qPBh76hco0fvTKNYAhq-P7reOHDwgQIK23hNn8SGG4bvKdCALwUGk1l3pCCWCfoyn3ukEv pMCP5kQIk.YBnbrAEQN7LQH1FRIhdQKwcnVjNKCGnIeVp7VW-OKNE&dib_tag=se&keywords=bt3000+table+saw+parts&qi d=1708790071&sprefix=BT3000%2Caps%2C125&sr=8-1

ALso have the drive belts set for $20
https://www.amazon.com/Replacement-D...s%2C186&sr=8-2