This is going to sound incredibly stupid, but my Central Pnuematic 3/8" regulator / filter is leaking somewhere. It sounds like a quiet little whoopie cushion. I have sprayed it down all over repeatedly but do not see any bubbles.
I am starting to wonder if the leak itself is IN the gauge behind the face since that is the only surface where there is any potential for leak that I can not get to with the soapy water mixture.
I like this setup because of the FRL connection brackets that seem to be not a feature carried over, or at least advertised on the Merlin branded units, and really the other side of the assembly is fine.
Which begs the question.
Where can I obtain a replacement gauge to be able to keep the function and stop the leakage?
Pretty sure it is a 1/4" MPT fitting.the only rear fitting gauge from HF I have seen is a 1/8". I guess I could use a bushing but I would rather not...
I am starting to wonder if the leak itself is IN the gauge behind the face since that is the only surface where there is any potential for leak that I can not get to with the soapy water mixture.
I like this setup because of the FRL connection brackets that seem to be not a feature carried over, or at least advertised on the Merlin branded units, and really the other side of the assembly is fine.
Which begs the question.
Where can I obtain a replacement gauge to be able to keep the function and stop the leakage?
Pretty sure it is a 1/4" MPT fitting.the only rear fitting gauge from HF I have seen is a 1/8". I guess I could use a bushing but I would rather not...
Comment