Howdy - just started assembling a deck rail modification - lots of Port Orford cedar, vertical louvers uppers, solid cedar lowers (below railing). Combo wind and sun screening etc. First screw - pre drilled through fastening piece, but not into anchor piece. Screw snapped. OK - I'll drill them all going forward.
But, I do have a question. I used an impact driver - which I am admittedly new to. Should I have just slowly screwed that screw in with my drill? Do impact drivers have bigger failure rates with the more brittle stainless?
But, I do have a question. I used an impact driver - which I am admittedly new to. Should I have just slowly screwed that screw in with my drill? Do impact drivers have bigger failure rates with the more brittle stainless?
Comment