I am about to start a project where I will need to cut a bunch of small acute angles < 30 degrees. To make it trickier many of them need to be on stock 6' long.
My CMS cant be set for much less than 40 the SMT around 35 and the miter gauge on my BS at 30.
The options I have come up with all require angled support jigs that will let me either
a) use the rip fence on either the TS or BS
b) attach to the CMS fence to get the correct angle
c) use the BS miter gauge or SMT
What have any of you folks done to solve this problem and which do you think would be the easiest and safest way to go?
My CMS cant be set for much less than 40 the SMT around 35 and the miter gauge on my BS at 30.
The options I have come up with all require angled support jigs that will let me either
a) use the rip fence on either the TS or BS
b) attach to the CMS fence to get the correct angle
c) use the BS miter gauge or SMT
What have any of you folks done to solve this problem and which do you think would be the easiest and safest way to go?
Comment