I have read a lot about using 1/4 inch hardboard as a final surface for a laminated bench top. I understand that this is a good idea as it provides a good surface and is easy and cheap to replace.
My question is how should this be fixed such that it is in fact easily replaceable? If its glued wont that make replacement messy and might affect the under layers. If its screwed in then that leaves holes in what I would think ideally needs to be a flat surface.
Puzzled from Phoenix
(AKA Jon)
My question is how should this be fixed such that it is in fact easily replaceable? If its glued wont that make replacement messy and might affect the under layers. If its screwed in then that leaves holes in what I would think ideally needs to be a flat surface.
Puzzled from Phoenix
(AKA Jon)
Comment