So, this is going to be a bit of a running thread, but here goes.
My truck shell camper build is almost ready to accelerate.
So the bed platform / cabinet is done, but needs to be redone. Mostly to get the platform tighter up against the sides of the truck bed.
The platform is basically a bead board and 2x2 box with a 1/2" hinged plywood deck. Unfortunately I did not get it tight enough to the bed sides. Will work on that a bit more as I believe I can eke out at least 2" inches to allow for aisle and the more important, electrical compartment.
I have 2 batteries that need to be housed. 9.5" wide x 9x5" high x 21" long.
I am planning on using 1/2" ply and will make the corners with 1/4" dowels and at the very bottom, and very top will have 45 degree corner braces glued in.
So this weekend, time to grab some plywood. Yay!
My truck shell camper build is almost ready to accelerate.
So the bed platform / cabinet is done, but needs to be redone. Mostly to get the platform tighter up against the sides of the truck bed.
The platform is basically a bead board and 2x2 box with a 1/2" hinged plywood deck. Unfortunately I did not get it tight enough to the bed sides. Will work on that a bit more as I believe I can eke out at least 2" inches to allow for aisle and the more important, electrical compartment.
I have 2 batteries that need to be housed. 9.5" wide x 9x5" high x 21" long.
I am planning on using 1/2" ply and will make the corners with 1/4" dowels and at the very bottom, and very top will have 45 degree corner braces glued in.
So this weekend, time to grab some plywood. Yay!
Comment