How do I make this joint/notch? half inch deep and wide. Probably 2" or so long. Obviously I can use a rabbet bit or a 1/2" straight router bit but then I have to chisel the corner out on every one of them.
Is there any way to make a square inside corner without a corner chisel (I do have one, just a relative pain to use). It's going to be a little wide than the corner chisel (3/8") anyway.
Mortiser would not work because the bottom tends to be quite rough and irregular. I want two or three smooth sides.
How do I make this joint/notch? half inch deep and wide. Probably 2" or so long. Obviously I can use a rabbet bit or a 1/2" straight router bit but then I have to chisel the corner out on every one of them.
Is there any way to make a square inside corner without a corner chisel (I do have one, just a relative pain to use). It's going to be a little wide than the corner chisel (3/8") anyway.
Mortiser would not work because the bottom tends to be quite rough and irregular. I want two or three smooth sides.
Comment