Hi everyone! I'm a new Sawdustzone member and new owner of a BT3000, recently picked up on Facebook Marketplace. I've been poring through the forums here as well as the BT3K FAQ, but I haven't been able to find an answer to my problem.
It appears that the blade on my saw is not square to the table. When I turn the bevel knob to 0, the blade is just slightly off. I've attached a photo, and you should be able to see that there's a gap between the blade and the square at the bottom by the throat plate.
Is there a way to adjust the bevel?
Thanks in advance for any help.
Joe
It appears that the blade on my saw is not square to the table. When I turn the bevel knob to 0, the blade is just slightly off. I've attached a photo, and you should be able to see that there's a gap between the blade and the square at the bottom by the throat plate.
Is there a way to adjust the bevel?
Thanks in advance for any help.
Joe
Comment