Hello Gurus,
Now that my saw is raising and lowering I am excited to build more accessories for my saw.
Trying to make my first ZCTP and struggling to figure out the correct cutouts. Which holes do you guys use to secure the ZCTP. Do you guys use A & C or B & D in my photos?
Also I am trying to understand what mpc has tried saying in this post -
I tried making one that sits on the lower tabs (like in photo 3) following the above post and ignoring the 0.1" lip. But that doesn't seem right. The drop of 0.1" or so seems big enough for the material being cut to get obstructed on the rear side. Clearly I haven't understood that post correctly.
May I see some photos of ZCTPs you have built.
Thanks a bunch in advance.
NG
Now that my saw is raising and lowering I am excited to build more accessories for my saw.
Trying to make my first ZCTP and struggling to figure out the correct cutouts. Which holes do you guys use to secure the ZCTP. Do you guys use A & C or B & D in my photos?
Also I am trying to understand what mpc has tried saying in this post -
I tried making one that sits on the lower tabs (like in photo 3) following the above post and ignoring the 0.1" lip. But that doesn't seem right. The drop of 0.1" or so seems big enough for the material being cut to get obstructed on the rear side. Clearly I haven't understood that post correctly.
May I see some photos of ZCTPs you have built.
Thanks a bunch in advance.
NG
Comment