Hi all, I hope someone can help me with a problem that has me stumped.
When I lower the blade on my B3100 it will drop suddenly once it reaches a certain height. After the drop it will lower as it should. When i raise the blade it will go up a certain distance and then stop. If I lift the motor an inch or so the mechanism re-engages and the blade can be raised to full height.
I have stripped down the saw,cleaned,. etc... but can not fix the problem.
I do not think the threads on the aluminum arbor are stripped because the blade will raise and lower normally except at a certain point.
Any ideas??
When I lower the blade on my B3100 it will drop suddenly once it reaches a certain height. After the drop it will lower as it should. When i raise the blade it will go up a certain distance and then stop. If I lift the motor an inch or so the mechanism re-engages and the blade can be raised to full height.
I have stripped down the saw,cleaned,. etc... but can not fix the problem.
I do not think the threads on the aluminum arbor are stripped because the blade will raise and lower normally except at a certain point.
Any ideas??
Comment