LCHIEN
Liking my Freud Forstner set but the layout always leaves me hunting for the size I need. Not in totally logical order, Hard to identify by reading the etching on the shank, because its usually not label side up and its hard to read. Finally labeled them with my P-Touch
-
Last edited by LCHIEN; 02-06-2026, 02:50 PM.
Loring in Katy, TX USA
If your only tool is a hammer, you tend to treat all problems as if they were nails.
BT3 FAQ - https://www.sawdustzone.org/forum/di...sked-questions -
Good idea, and yet my cheap GRIP set has the sizes molded into the case next to each bit recess.Jim Frye
The Nut in the Cellar.
I've gone out to look for myself. If I return before I get back, have me wait for me. -
My older set was in a box in increasing size easier to find. They alternated up and down so they fit most compactly as well as Being in order. I considered swapping the Freud set into the Harbor Freight box!
Loring in Katy, TX USA
If your only tool is a hammer, you tend to treat all problems as if they were nails.
BT3 FAQ - https://www.sawdustzone.org/forum/di...sked-questionsComment
Comment