So my pocket hole jig has taken to basically destroying work pieces due to a dull bit. I have new bits en route, but I am wondering, because of the step nature of the bits, is it even possible to sharpen these bits and if so, who can do it or is it just cheaper / easier to pitch them in the recycle bin and buy new ones?
-
Please like and subscribe to my YouTube channel. Please check out and subscribe to my Workshop Blog. -
https://www.facebook.com/watch/?v=1011906842521350
https://kregjig.ning.com/forum/topic...hole-drill-bit
also this may be informative
https://www.youtube.com/watch?v=A25IAc_PCfI
If you search amazon or do a google search, there are some much cheaper alternatives, depends on whether the KREG name impresses you.Last edited by LCHIEN; 11-02-2023, 04:28 PM.
Loring in Katy, TX USA
If your only tool is a hammer, you tend to treat all problems as if they were nails.
BT3 FAQ - https://www.sawdustzone.org/forum/di...sked-questions
LCHIEN
Comment