My table saw seemed out of alignment. I got out my Master plate and dial from front of the blade to back of the blade is off by .01. The manual states: Loosen the trunnion bolts shown in Figure 57. Under Figure 57 it indicates 6 bolts but it also says “not all the trunnion bolts are shown”).
Does anyone know how many trunnion bolts this saw has? I can only locate 6. I loosened the bolts. With the bolts lose I was able to adjust the trunnion assembly get the measurement down to .03 but that’s all. I’m very frustrated with this, can anyone help. I’m trying to contact Grizzly but their tech support doesn’t have a 1-800 number and I don’t have long distance so I’m in the process of email them.
Can anyone with this saw help me out?
Thanks
Angela
Does anyone know how many trunnion bolts this saw has? I can only locate 6. I loosened the bolts. With the bolts lose I was able to adjust the trunnion assembly get the measurement down to .03 but that’s all. I’m very frustrated with this, can anyone help. I’m trying to contact Grizzly but their tech support doesn’t have a 1-800 number and I don’t have long distance so I’m in the process of email them.
Can anyone with this saw help me out?
Thanks
Angela
Comment