My Unisaw stopped working just now. I was in the middle of some cuts, which means a lot of repetitive cuts. After a handful done, when I turned it on, it wont start.
I tried the non-contact power tester, and it shows there is power (as before) at the junction box on the TS. But when I press the green button, it just sits there.
So, what are my options now? I could open the box up, but don't think I can really understand it; will it be a straightforward fix ?
I tried the non-contact power tester, and it shows there is power (as before) at the junction box on the TS. But when I press the green button, it just sits there.
So, what are my options now? I could open the box up, but don't think I can really understand it; will it be a straightforward fix ?
Comment