X-workhorse

[Thom2]

yeah, those are nice, too bad they each cost as much as the table.

I've seen those somewhere else for a lot less money, but can't think of where

[LCHIEN]

I found it. I think Tom Miller's Home made vise is just what this bench needs.

http://www.bt3central.com/showthread...vise+home-made

[RodKirby]

Kirby version...

[gwyneth]

Rod,

Beautiful.

I know how annoying it is when people ask you about the one angle you didn't shoot, but if the thread goes into the pipe clamp fitting, how does that sit/adhere in the outer jaw?

[RodKirby]

Rod,

Beautiful.

I know how annoying it is when people ask you about the one angle you didn't shoot, but if the thread goes into the pipe clamp fitting, how does that sit/adhere in the outer jaw?

Here's the rest of the pics... Plywood covers screwed only - no glue

[Bruce Cohen]

I've been using one on a mobile base as a stand for m bench 12" Drill Pres, A heck of a lot easier than building one, cheaper too.

Bruce

[Uncle Cracker]

The B&D branded version of these is in the latest HF mailout, priced at $25 (and there's a 15% off coupon in the same mailout). Says it's a closeout, and that quantities may be limited.

[BearPipes-1]

The current HF flyer (the "Lower than Discount" one) has this listed as Lot No. 55596, $24.99.

"X-Horse"
Black & Decker
Here's an all-purpose work stand that can be used as a power tool stand, worktable or sawhorse. Rugged work plate has V-grooves for round stock.
* Folds flat for easy storage
* Heavy duty construction
* Adjustable aluminum legs
* 750 lb. capacity
Closeout!
Limited Quantities!