I made an ironing board from cheap pine. When in use it will be wrapped in the standard foam+cotton cover.
What sort of a finish is best for this? Acrylic (or latex) paint? Or tung-oil/Shellac finish? Or just lacquer?
While the hot iron will not touch it directly, I believe quite a bit of heat will be transmitted...
I am okay re-finishing it at some interval, don't expect any finish to last forever.
What sort of a finish is best for this? Acrylic (or latex) paint? Or tung-oil/Shellac finish? Or just lacquer?
While the hot iron will not touch it directly, I believe quite a bit of heat will be transmitted...
I am okay re-finishing it at some interval, don't expect any finish to last forever.
Comment