Tweet
Does anyone have a good way of using a feather board on the BT3100 (other than your free hand)? 
-
-
I have one that mounts on the SMT in place of the miter fence. Two slots in the feather board and two 5/16 (?) hex bolts in the SMT slot to hold it in place.
Almost forgot, "What the magnetic ones don't work for you?'
Bill -
Like Mr. Bll suggests.
Or, like this:
Loring in Katy, TX USA
If your only tool is a hammer, you tend to treat all problems as if they were nails.
BT3 FAQ - https://www.sawdustzone.org/forum/di...sked-questionsComment
-
Uh, okay I wish I had a photo of it... 2 @ 5/16" bolts, and my Rockler long featherboard, the one from the router table accessory kit, and the star knobs and I am good to go... The other way to go is with the miter slot accessory...Please like and subscribe to my YouTube channel. Please check out and subscribe to my Workshop Blog.Comment
-
Thanks,guys. I had this in mind but wasn't sure it would work. And no, my magnets must be getting weak!Comment
Comment