Hi all,
I recently received a newsletter that shows how to do lap joints on the table saw here:
http://www.woodworkersjournal.com/re...nts/index.html
I don't have a dado setup on my table saw, but would like to try this on the router table. Here's my question: would you route the lap joints from the inside and work your way to the edge (as shown in the tablesaw pics), or would you start on the edge and nibble your way in?
Thanks for your help,
--tlt
I recently received a newsletter that shows how to do lap joints on the table saw here:
http://www.woodworkersjournal.com/re...nts/index.html
I don't have a dado setup on my table saw, but would like to try this on the router table. Here's my question: would you route the lap joints from the inside and work your way to the edge (as shown in the tablesaw pics), or would you start on the edge and nibble your way in?
Thanks for your help,
--tlt
Comment