I have a stack of lumber from the Lumber Liquidators woodworkers pack of a couple of years ago. I have run some of it through the Jointer and have a flat face a 90 deg edge. Some of the wood it is thicker on one side than the other and on some on end is thicker. I guess you would run the thicker end through first, but how do you handle the board that is thicker on one edge than the other? On some boards it is about 1/4" - 3/8" difference. Don't want to put the board through the wall of my shop. Simple answer would be run it through and take a little off at a time. Just want to make sure of what i am doing.
Tom
Tom
Comment