I used the mitre slot on my BS 2 days ago to cut shoulders on tenons after cutting the up-rights with a tenoning jig on the TS. The miter gauge moved the drawn line at a 90 degree anlge to the blade to meet the already severed upright protion of the tenon cheeks.
As Pappy stated, drift can occur as a result of several factors.. one being the blade.. too little tension.. wheels not co-planular.. guides improperly set.. worn tire.. sawdust build-up on tire.. etc. etc..
All BS's have the basic same components but that does not mean they are all equal. I don't get drift on my Steel City 18" with the proper set-up.. matched blade to what I'm doing.. HP.. very healthy double tension springs.. etc. etc. I do on my Jet.. You have to adapt to what your BS can do under optimum conditions and it's capabilities. If you get drift when everything is right with the saw included proper blade match.. you either adjust for drift with the fence as described... or learn to use a point fence which only gives contact with the stock a one small axis point and guide it through by hand.
But..... I highly suggest you get a BS book and learn about the BS from ground zero. It is the most finicky machine in the shop but also one of the most flexible and useful..
Regards...
Resawing for Beginners
Collapse
This topic is closed.
X
X
-
Guest replied -
My understanding is that drift is caused by the blade, not the saw. I did a lot of resawing yesterday with a Timberwolf 1/2" 3 TPI in Mahogany and Oak up to 8" wide. Didn't have any problem with blade drift.Leave a comment:
-
Here's a method that does not use a t-bevel.
http://www.rd.com/americanwoodworker...ain/page4.html
Quite similar to the method with the t-bevel.
________
Live SexLast edited by newbie2wood; 09-15-2011, 05:43 AM.Leave a comment:
-
What to do if I dont have a slide bevel ? I understand what you are saying. I actually did just that, and marked a line with a pencil and sent the fence on that.
Side question. Why would a bandsaw have a miter slot/guide if the cuts always drift ?Leave a comment:
-
The traditional way of measuring blade drift is to take a 2" thick piece of stock, mark a line that is parallel to the edge (about 2" in from the edge or so), and freehand cut the line. Stop after about 6" into the cut, then use a sliding T bevel to get the angle. You are compensating for the drift to cut the line straight, and this is the angle to which you want to set your resaw fence.
Cut another 6" and confirm the angle, once you are pretty sure of the angle, adjust your fence to that angle. Every BS fence has a slightly different method of making this adjustment, but that's the ticket.Leave a comment:
-
-
What I do is start with a test piece that is straight and I would cut it first and look at the direction of the cut then back off the piece and use a T-Bevel Sliding Square to figure out the angle of the cut and would use that as a guide to adjust the bandsaw fence so that it is parallel with the cut in the test piece. Works for me everytime.Leave a comment:
-
Resawing for Beginners
Well just recently got a band saw and could use some help with resawing and the methodolody behind it.
I have noticed that when I set the fence straight to the blade and resaw the cut begin to walk from where it started. This is blade drift. Now how does one deal with this ?
Thanks in advance for the help.Tags: None

Leave a comment: