Folks,
The attached two are my first 2 projects. Your comments are appreciated.
Also, in my previous post, it was indicated to have an outfeed table on my saw. Question is - what is the size of this table? Will a 3 x 4 do? At one point the outfeed table may come in the way of the SMT.
Thanks again.
The attached two are my first 2 projects. Your comments are appreciated.
Also, in my previous post, it was indicated to have an outfeed table on my saw. Question is - what is the size of this table? Will a 3 x 4 do? At one point the outfeed table may come in the way of the SMT.
Thanks again.
Comment