I haven't had this happen in the past, but this is the first time in a long time that I have used a feather board. I had a feather board clamped to the SMT holding some small pieces against the rip fence. As I was running the work, I noticed an inconsistency in the cuts and that is when I saw the rip fence flexing with the hold down pressure from the feather board. Is this a common occurrence or do I have something out of whack?
I released some of the tension on the feather board, which seemed to help a little but now I do not get the holding pressure I was really wanting.
Thanks.
I released some of the tension on the feather board, which seemed to help a little but now I do not get the holding pressure I was really wanting.
Thanks.
Comment