So last weekend, I was putting the saw back in my garage. Unfortunately, I had it back on the castors and grabbed it by the sliding miter table which was loose. I dumped it - broke the main table.
So I found another main table on Ebay and received it in the mail yesterday.
I started to take it off - and man the four screws around the hold the gimbles where the saw pivots are torqued down so much that I cannot get them off - I am really afraid of stripping them.
Is there an trick or tips you guys have to get the main table off and apart from the saw. This turned out to be a way bigger project that I expected it to be because of those four little screws.
Thank you very much in advance for your replies.
Eric
So I found another main table on Ebay and received it in the mail yesterday.
I started to take it off - and man the four screws around the hold the gimbles where the saw pivots are torqued down so much that I cannot get them off - I am really afraid of stripping them.
Is there an trick or tips you guys have to get the main table off and apart from the saw. This turned out to be a way bigger project that I expected it to be because of those four little screws.
Thank you very much in advance for your replies.
Eric
Comment