What am I missing?
I need to cut some 45 degree bevels with the BT3100 but found that the blade will not go all the way over to 45 degrees with the Shark splitter in place. I tried it with the Ryobi throat plate and with a ZCTP plate that had been widened to allow some beveling. I have not had any problems with other bevel cuts (up to about 35 degrees).
All suggestions appreciated. Thanks.
I need to cut some 45 degree bevels with the BT3100 but found that the blade will not go all the way over to 45 degrees with the Shark splitter in place. I tried it with the Ryobi throat plate and with a ZCTP plate that had been widened to allow some beveling. I have not had any problems with other bevel cuts (up to about 35 degrees).
All suggestions appreciated. Thanks.
Comment