http://slickdeals.net/f/4101364-Irwi...-5-Lowe-s-YMMV , might be something folks here might need or want, I use my blade to sight off of rather than these,but some here might like
Possible deal on Irwin Miter saw laser
Collapse
This topic is closed.
X
X
-
i got one of these when Rockler was had them on sale, I think like $15? They work OK.
No replies means that anyone of them could have gotten it or already had one or maybe had no luck finding it.
Actually Rockler has them for $9.99 right now. I have a no-minimum free shipping code if anyone needs it.
http://www.rockler.com/product.cfm?p...2&site=ROCKLERLast edited by LCHIEN; 03-22-2012, 06:50 PM.Loring in Katy, TX USA
If your only tool is a hammer, you tend to treat all problems as if they were nails.
BT3 FAQ - https://www.sawdustzone.org/forum/di...sked-questionsComment
-
...Actually Rockler has them for $9.99 right now. I have a no-minimum free shipping code if anyone needs it.
http://www.rockler.com/product.cfm?p...2&site=ROCKLERthere's a solution to every problem.......you just have to be willing to find it.Comment
-
i got one of these when Rockler was had them on sale, I think like $15? They work OK.
No replies means that anyone of them could have gotten it or already had one or maybe had no luck finding it.
Actually Rockler has them for $9.99 right now. I have a no-minimum free shipping code if anyone needs it.
http://www.rockler.com/product.cfm?p...2&site=ROCKLERComment
-
Yup, they aren't designed for accuracy, just speed cuts like for decking,framing,etc, if you need one they work fine for that, when using any saw for accuracy like I said I always sight off the blade, don't think I would have tossed one just because of that. I have used them before building decks etc when accuracy is no big deal as a sander is gonna finish off that 1/32 or 16th these are going to cut over or under depending on where you mount it as with any tool its use is what you make of it. As I recall it says so on the package cuts to either side of the lasr line depending on where you mount itJust have to know how to use itComment
-
....Actually Rockler has them for $9.99 right now. I have a no-minimum free shipping code if anyone needs it.
http://www.rockler.com/product.cfm?p...2&site=ROCKLERthere's a solution to every problem.......you just have to be willing to find it.Comment
-
Actually Rockler has them for $9.99 right now. I have a no-minimum free shipping code if anyone needs it.
http://www.rockler.com/product.cfm?p...2&site=ROCKLER
http://www.homedepot.com/webapp/wcs/...5f%2d100375598Comment
-
I don't like or use the saw lasers. IMO, not even accurate for close to rough cuts. I would prefer they leave them off the tools, and reduce the cost of the tool.Comment
Footer Ad
Collapse
Comment