Whilst cleaning up I found an old BT3central post by ejs1097 I printed out from a while back. I had forgotten about it.


I made some changes and whipped out a few in a couple of evenings.
What I liked about them was they hold the sandpaper tight and snug, the bought ones the paper works loose and sags and gets caught and tears.
Also easy and cheap. Also has a square end for sanding into corners and a radius to do curves. I did modify the block so it used thicker stock...

I purchased some carbide cutters from AZCarbide (AZCarbide.com) to mount onto the lathe tools I made, including a 15mm 4inch radius (#RA4), a 14x28mm diamond (#DIA14), a 14mm square (#SQ14), and 16mm round (#RD15). I can't say enough good things about Dale Guilford, the proprietor, and his helpfulness. He sent an email to confirm the order, and responded in short order to some questions I had. The cutters were shipped flat rate for $2, and I received them in just a couple days. They were carefu...

After my $1.89 tool review a couple of days ago, I'm shooting for a even lower priced tool review. I don't think anyone can beat this one! Has 32 drill sizes Made in USA! Handy hole for hanging Beautiful black plastic finish won't damage your sharp edged tools (but the tools might damage the gauge) relief bumps 10 mils high for drawing, perhaps? THis came free along with an offer to evaluate tools for free and keep the tools. I don't fall for that Malarky. But the drill bit guide is possibly ...