Turning In Mach III

[Richard in Smithville]

Ok, not in mach three but how about a Mach III? I pick up some Mach III kits at the last woodshow I attended and mixed it up with a Leopard print blank. I think it turned out well.





Kit and blank from William Wood-write.

Thanks for looking.

[phrog]

Really, really nice, Richard. Was it a difficult kit to assemble?

[leehljp]

That is a VERY nice looking piece of work! Well done and great choice of a blank.

[Richard in Smithville]

Thanks guys. The kit was very easy to put together. The only problem I encountered was blade end needed a drop od CA to hold it tight.

[gerti]

That is really cool! Almost wants me to go back to the Mach III. But I think their blade quality really declined over time, seemed after a two or three shaves they were dull. I switched to the Schick Hydro, much closer shave and the blades last longer.

[Stytooner]

My CNC lathe uses Mach 3 for turning.
It hasn't turned out anything that nice yet though. Great job on selection and finishing. You aren't going to use it, are you?

[Whaler]

Looks great Richard.

[Turaj]

Richard, That looks really nice! If you can bring it to the show (along with some of your pens), I love to see them first hand. (I am assuming that you are coming to the show!).

[Richard in Smithville]

Thanks guys. I don't have any plans to use it. Will most likely gift it out. I plan on coming to the show Turaj. Gord G has been asking about that too. Will you be working it again?