i've started my diy table saw

[Thom2]

thanks for the link thom2. i enjoyed reading about the forge they built, after reading this i went to the shop and put together one of my own. what do you think?

i should of snaped a few shots of it in action , it uses alot of air so i'm going to have to build a bigger compressor ( he he he another diy project i need to complete) for the mean time i have an old water tank i'm going to turn into another tank for my compressor so it holds more air.

since i'm waiting on parts for my table saw i thought i would work on another project i had in mind for my delta planer i'll post this in another thread
later blame

That looks like it should work, I'd seriously think about using a shop vac for your air supply tho'. The shop vac will give you a lot more volume than a compressor will, this application needs volume and not pressure.

At least give the shop vac a try, I really think you'll find it suits this application better.

[blame]

yeah i think your right thom volume is alittle lacking from the compressor i dont have a shop vac that blows air but i do have a squirrel cage blower from an old dryer should do the trick i'll give it a try and see what happens

later blame