Do you have a router table?

[JimD]

My router table sits in the infeed side of the table saw and has functioned as infeed support (with the fence removed) for the table saw. Now that I have a track saw, I don't envision ever wrestling a sheet of plywood through the table saw ever again. On the infeed side of the router table is the garage door. So for long pieces, I have to open the door.

Jim

[Tom Clark]

Space is always tight, no matter how much you have. My router table doubles as a big storage box for router bits, shaper bits, c-clamps, and shop fixtures. The router actually takes very little room. Dust collection is from below via a shop vac that is controlled via a switch near the router switch. A 1/4" round over bit is left in the router most of the time, and it seems like it is in use daily.

The table is over 20 years old and I couldn't do without it…