I have my DC set up with a 2.5" flex hose available at my work bench. I'm going to start looking into how to connect this to my Porter Cable Router dust port, RO sander dust port, etc. This would be for hand-held operations, not table mounted operations. I haven't measured anything yet but these ports seem smaller than shop vac connections so I'm pretty sure they won't work.
Before I go looking at tool manufacturer's web sites and on-line shops like Rockler, any suggestions out there to speed up my search?
Before I go looking at tool manufacturer's web sites and on-line shops like Rockler, any suggestions out there to speed up my search?
Comment