Table top with breadboard endings

Collapse
This topic is closed.
X
X
 
  • Time
  • Show
Clear All
new posts
  • capncarl
    Veteran Member
    • Jan 2007
    • 3564
    • Leesburg Georgia USA
    • SawStop CTS

    #16
    Radhak. The areas of the tongue and groove on the breadboard/table top slab where the kreg type screws penetrate the groove, I just cut out about 1" of the tounge. That way the wood screw doesn't split and expand the tongue and bind the breadboard.
    I like to make my table slab overhang the aprons about 6", I like the way it looks with the legs set back under the table rather than being near the edge.
    Capncarl

    Comment

    • radhak
      Veteran Member
      • Apr 2006
      • 3058
      • Miramar, FL
      • Right Tilt 3HP Unisaw

      #17
      Wow - good input, Cap. I will want to make the tongue/groove blind too. And I had not considered the risk of the tongue expanding due to the screws. Lemme file that way.

      Thanks!
      It is the mark of an educated mind to be able to entertain a thought without accepting it.
      - Aristotle

      Comment

      Working...