Has anyone here ever used a commercial taper jig set to zero degree taper to make repetitive thin cuts safely?
Paul
Paul
-
-
i don't see the point of that compared to using other jigs, unless its because the other jigs had to be made (none of them complex) vs.using the taper jig because you already had it.
Loring in Katy, TX USA
If your only tool is a hammer, you tend to treat all problems as if they were nails.
BT3 FAQ - https://www.sawdustzone.org/forum/di...sked-questions -
Take a look at this
Paul,
Rod Kirby did something that you might want to take a look at, It's an idea that's "buried" in this presentation of his Miter Fence improvement.
It's a method of Ripping very accurate narrow strips from a larger piece of stock.
It's a Fairley simple proceedure, once you understand the principle.
http://www.bt3central.com/articles/files/Smtextn1-1.pdfStop thinking why you can't and Start thinking how you CAN!
Remember, SUCCESS comes in CANS!
GeorgeComment
LCHIEN
Comment