Parting BT3000

Collapse
This topic is closed.
X
X
 
  • Time
  • Show
Clear All
new posts
  • smackd78
    Handtools only
    • Jul 2011
    • 3

    Parting BT3000

    i am parting out my BT3000. I recently got a nwer saw and don't have room for both saw. Below is what i have available.

    the sliding miter table was drop a few weeks ago and actaully broke the top of the table. The lifting mechinisim is also stripped out as well. I am keeping the stand as i will be using it on my new saw. I am central florida. make a resonable offer on price, would prefer local.

    standard rails (silver)
    broken (miter sled)
    aceessory table
    blade guard
    standard motor (not sure of amps, not labeled)
    zero clearance insert (1 cut, 1 uncut)
    dado insert
    rip fence
  • LCHIEN
    Internet Fact Checker
    • Dec 2002
    • 20920
    • Katy, TX, USA.
    • BT3000 vintage 1999

    #2
    whats numbers on the label plate on the back of the saw?
    Amp listed there will be the motor amps.
    The serial number will reveal the build date, too.
    Loring in Katy, TX USA
    If your only tool is a hammer, you tend to treat all problems as if they were nails.
    BT3 FAQ - https://www.sawdustzone.org/forum/di...sked-questions

    Comment

    • smackd78
      Handtools only
      • Jul 2011
      • 3

      #3
      Ok ,it was on the side panel (i had it removed so that i can move the saw up and down since) below is what is stated on the label

      RYOBI 10" TABLE SAW
      BT-3000 Ser No 795184 9416
      120 V.AC * 15A * 60 HZ * 4800 R.P.M.

      Comment

      • LCHIEN
        Internet Fact Checker
        • Dec 2002
        • 20920
        • Katy, TX, USA.
        • BT3000 vintage 1999

        #4
        Originally posted by smackd78
        Ok ,it was on the side panel (i had it removed so that i can move the saw up and down since) below is what is stated on the label

        RYOBI 10" TABLE SAW
        BT-3000 Ser No 795184 9416
        120 V.AC * 15A * 60 HZ * 4800 R.P.M.
        9416 = 1994, week 16 (approx late March), build date.
        Loring in Katy, TX USA
        If your only tool is a hammer, you tend to treat all problems as if they were nails.
        BT3 FAQ - https://www.sawdustzone.org/forum/di...sked-questions

        Comment

        • All Thumbs
          Established Member
          • Oct 2009
          • 322
          • Penn Hills, PA
          • BT3K/Saw-Stop

          #5
          If it has the solid aluminum (or whatever, just not plastic) handwheel, I'll take that.

          Comment

          • smackd78
            Handtools only
            • Jul 2011
            • 3

            #6
            Someone beat you to the handwheel, but if it falls through i will get back with you.

            Comment

            Working...