Lost a topic I was hoping to get an answer from

Collapse
This topic is closed.
X
X
 
  • Time
  • Show
Clear All
new posts
  • lcm1947
    Veteran Member
    • Sep 2004
    • 1490
    • Austin, Texas
    • BT 3100-1

    #1

    Lost a topic I was hoping to get an answer from

    Looks like I lost a topic that I was waiting to get a reply on about something I think could be important so thought I'd create a new post and ask about it. Long story short is it Ok, meaning safe to run wiring in the ceiling over another wire, you know like one actually lying across another? Both are 12 gauge wrapped (The yellow stuff you buy at any Lowes or HP).
    May you die and go to heaven before the Devil knows you're dead. My Best, Mac
  • crokett
    The Full Monte
    • Jan 2003
    • 10627
    • Mebane, NC, USA.
    • Ryobi BT3000

    #2
    I surely hope so. There is wiring like that in my basement, not to mention places where there are 2 wires sharing the same hole that is drilled through a joist. But mebbe NEC code was different when my house was built 30 yrs ago.
    David

    The chief cause of failure in this life is giving up what you want most for what you want at the moment.

    Comment

    • LCHIEN
      Super Moderator
      • Dec 2002
      • 21971
      • Katy, TX, USA.
      • BT3000 vintage 1999

      #3
      Originally posted by lcm1947
      Looks like I lost a topic that I was waiting to get a reply on about something I think could be important so thought I'd create a new post and ask about it. Long story short is it Ok, meaning safe to run wiring in the ceiling over another wire, you know like one actually lying across another? Both are 12 gauge wrapped (The yellow stuff you buy at any Lowes or HP).
      I'm not a NEC code person but form an engineering standpoint,
      it would be quite safe. Each wire has probably 600V insulation so between them it can withstand 1200 V to each other. The other problem with packing wires is overheating. When run at right angles it maximizes the free air heat dissipation and minimizes the close contact packing that can cause overheating of multiple wires carrying large currents.
      Loring in Katy, TX USA
      If your only tool is a hammer, you tend to treat all problems as if they were nails.
      BT3 FAQ - https://www.sawdustzone.org/forum/di...sked-questions

      Comment

      • lssm37
        Forum Newbie
        • Jan 2006
        • 6
        • Milford, DE, USA.

        #4
        Crossing wires

        Perfectly safe and within code with the type of wire you're using.
        Smitty

        Comment

        • sacherjj
          Senior Member
          • Dec 2005
          • 813
          • Indianapolis, IN, USA.
          • BT3100-1

          #5
          Running two power lines next to or over each other are not a problem. I generally try not to mix high and lower power (phone, cable, etc.). This is more from a signal standpoint and not a safety issue. I've had noise induced in lines from mixing a 60 Hz powerful magnetic field too close to other conductors.
          Joe Sacher

          Comment

          • lcm1947
            Veteran Member
            • Sep 2004
            • 1490
            • Austin, Texas
            • BT 3100-1

            #6
            Thanks

            Hey thanks for the good news guys. I've been a little worried ever since I read and evidently misunderstood that Post I lost. Sure appreciate the replies.
            May you die and go to heaven before the Devil knows you're dead. My Best, Mac

            Comment

            Working...