So I'm installing my first ZCI for my 22114 I got from Rockler. I planned on adjusting the side screws to make a snug fit, clamp down a piece of scrap particle board I have over the ZCI, turn the saw on and then slowly raise the blade. Is there anything I'm missing?
Also there's a hole at the end the guy said is there to be able to remove it. But doesn't that allow the dust to get in and thus nullifying the purpose of the ZCI? But then again I've never used a ZCI.
Also there's a hole at the end the guy said is there to be able to remove it. But doesn't that allow the dust to get in and thus nullifying the purpose of the ZCI? But then again I've never used a ZCI.
Comment