I have read some posts regarding blades on here but I was wondering if you guys could provide me with the best for my particular needs?
I cut almost exclusively 3/4 - 1 inch plywood. Still need a nice cut on that because all sides show even though I sand them down and paint over it for my finished projects.
I bought a thin kerf DeWalt blade at HD when I got my BT3100. It is all black and ran me about $70. Its got a lot of teeth and I haven't had any problems with it.
I don't mind spending the money as long as it's a good product that will last.
Also, How long will this DeWalt blade last me? I cut for 2-3 hours a day I suppose, again only plywood. What is a typical life on it, and what are some indications that I need to replace it? Also, is it dangerous if it gets too dull? Will I get kickback or anything? Thanks alot guys!
I cut almost exclusively 3/4 - 1 inch plywood. Still need a nice cut on that because all sides show even though I sand them down and paint over it for my finished projects.
I bought a thin kerf DeWalt blade at HD when I got my BT3100. It is all black and ran me about $70. Its got a lot of teeth and I haven't had any problems with it.
I don't mind spending the money as long as it's a good product that will last.
Also, How long will this DeWalt blade last me? I cut for 2-3 hours a day I suppose, again only plywood. What is a typical life on it, and what are some indications that I need to replace it? Also, is it dangerous if it gets too dull? Will I get kickback or anything? Thanks alot guys!
Comment