Router Table

[Luckbox]

It is not complete but it is at the usable state now. It is a bit overdone but thought it was a good chance to practice making cabinets. Had a couple minor issues. I had a minor issue with chip out at the right front some of where the router plat goes and my flush cut bit was just a little bit off when I was trimming the hardwood edge. I still need to build the drawers and doors but now that the table is usable I can use it to finish the table.

[twistsol]

Beautiful job! that should serve you well for many years.

[Pappy]

Be prepared to convince the 'boss' that the top is an intrical part of the cabinet and CANNOT be revoved without destroying the base. Otherwise, that is going to end up in the house......

[cabinetman]

Nice work...well done. You'll appreciate the effort when you use it.

.

[sweensdv]

Very nice Luckbox, you should be very proud of that piece.

[pelligrini]

That's pretty sharp. The Incra ought to make for some accurate cuts.

How is the dust collection working? Is there a hose that goes from the fence to the small port on the T?

[Luckbox]

Yes there is a 2.5" hose between the two. I hadn't fully set everything up when I took the pic.