My sliding miter is properly aligned and is set correctly to zero but when I go to 45 it is about 5 degrees off. Any idea why or what I'm doing wrong?
-
-
Where are you reading the miter angle? Be sure to read the angle at the back of the orange tab on the miter scale opposite the pivot pin.
Last edited by Black wallnut; 01-11-2009, 10:25 AM.Donate to my Tour de Cure
marK in WA and Ryobi Fanatic Association State President ©
Head servant of the forum
©
-
that's probably it, you need to read off the back edge of the orange-reddish indicator tab. you also have to have the black plastic bottom pivot in a hole (to the right is the usual choice) on the SMT.Last edited by LCHIEN; 01-11-2009, 11:28 AM.
Loring in Katy, TX USA
If your only tool is a hammer, you tend to treat all problems as if they were nails.
BT3 FAQ - https://www.sawdustzone.org/forum/di...sked-questionsComment
Black wallnut
Comment