Table Extension

[vrbradley]

Does anyone have suggestions and pictures of shop made legs to support extension rails?
I have searched and now need some advise.
Thanks

[maxparot]

I made 2 legs out of 2" Aluminum angle with a couple of pieces of 2 x 4 screwed between them and attached them with t-nuts. Quick simple and has held up well over the years.

[eezlock]

table extension

Table extension or rail extensions....either one is easily accomplished with
a couple of 1/2" or 3/4" black iron pipe threaded on both ends and 4 pipe floor flanges the type that screw onto the pipe and have 4 holes in them
for mounting to a floor or wall. These are relatively inexpensive and can be bought at hardware stores or the borg. Just have the pipes cut and threaded to proper length, screw a the flange on each end and mount one end to the rails and you are done!

[Ed62]

This is not exactly what you are asking, but check out this thread by LarryG. It might give you some ideas. http://www.bt3central.com/showthread...idth+extension

Ed