I just picked up a 21829 today. I put it together and checked it out. There is some horizontal slop in the SMT that needs to be adjusted out and the stand is going to need some tweaks because it's not rigid enough, both of these can be overlooked for most usage.
There is just one major problem that I've found, the top is not flat. If I put the aux table next to the main table and run a straight edge over the two, there is at least 1/8" of a gap on the far side of the main table with the straight edge flat on the aux table. If I put the aux table on the left side of the blade I've got closer to 1/4" gap. If I put the SMT beween the two tables the SMT is higher than either by at least 1/16-1/8", it varies accross the table.
Is this normal?
Can I adjust this out (I don't see how)?
There is just one major problem that I've found, the top is not flat. If I put the aux table next to the main table and run a straight edge over the two, there is at least 1/8" of a gap on the far side of the main table with the straight edge flat on the aux table. If I put the aux table on the left side of the blade I've got closer to 1/4" gap. If I put the SMT beween the two tables the SMT is higher than either by at least 1/16-1/8", it varies accross the table.
Is this normal?
Can I adjust this out (I don't see how)?
Comment