I notice that when I tilt my blade to 45-degrees, that the back of it tilts less (by approx. 1/100") than the front of it. Has anyone else ever seen this behavior?
Still trying to track it down. But I've had this happen before. Cuts with the SMT or a miter accessory table are perfectly square when the blade is set to 90-degrees. When I tilt the blade to 45-degrees, the cuts are no longer square.
Scratching my head as to what is going on.
And ideas?
Still trying to track it down. But I've had this happen before. Cuts with the SMT or a miter accessory table are perfectly square when the blade is set to 90-degrees. When I tilt the blade to 45-degrees, the cuts are no longer square.
Scratching my head as to what is going on.
And ideas?
Comment