This question gets asked a lot.
Mine:
(see attached image)
Cut a featherboard from a 1x4 about 15-18" long
Angle the tip 30 degrees.
Set the miter fence 30 degrees, use the miter clamp to hold the FB against the miter fence. Move the FB right-left to adjust, move the SMT on the rails to adjust more.
Move te SMT forwards backwards to set the FB contact point in front of the blade.
Use a quick-grip clamp (foreground, blue) to lock the SMT to the SMT base so it won't slide.
That's it.
Mine:
(see attached image)
Cut a featherboard from a 1x4 about 15-18" long
Angle the tip 30 degrees.
Set the miter fence 30 degrees, use the miter clamp to hold the FB against the miter fence. Move the FB right-left to adjust, move the SMT on the rails to adjust more.
Move te SMT forwards backwards to set the FB contact point in front of the blade.
Use a quick-grip clamp (foreground, blue) to lock the SMT to the SMT base so it won't slide.
That's it.
Comment