Since I have never used toggle clamps, what type of applications are you using these for? I need a reason to buy them! Thanks
-
What if there is no tomorrow?....there wasn't one today!
-Barry -
they make good hold downs for jigs and stuff where you have a piece clamped to a fixture which is aligned to the tool fences or reference points. The toggle hold down clamps mount to the side, and the lever arm apply quite a few pounds of pressure down to securely hold workpieces in place as you move the jig or tool. They're small/compact and more reliable and expendable than fingers.
Loring in Katy, TX USA
If your only tool is a hammer, you tend to treat all problems as if they were nails.
BT3 FAQ - https://www.sawdustzone.org/forum/di...sked-questionsComment
-
Like Loring said, they're great for jigs.
I've used them in other applications too. This is a knock down tournament bracket board. The toggle clamps aren't the prettiest solution, but it sure makes it easy to switch out the different sized brackets.
ErikComment
LCHIEN
Comment