I got lazy and just drilled / ran in a couple of 5/16" thread inserts. These are 5/16-18 inserts since all of my star knobs are 5/16-18. The original Grizzly pieces thread in, but not super well, they may be some funky Metric thread not sure. Going to grab some 5/16 all thread and finish this up soon, like tomorrow.

I had to move the thread inserts back and out a bit in order to be able to install the woodworking DP table as the original location for the anchors puts the table about 1.15" too far back and into the column. This clears the column but just barely...

This was to accomodate the new Bilt Hard benchtop 12" VS Drill Press.

I am not sure why it makes a new post when I try to post a picture to my gallery.

Anyway just a basic move of the thread anchors for the attachment point since the new DP table doesn't work with my existing woodworking drill press table.